Coral Springs Fence Pros

Home  ›  Common Problems  ›  Chain Link Fence Sagging

Address Soon

Chain Link Fence Sagging
in Coral Springs, FL

A sagging chain link fence looks bad but it's also a real security and containment problem. Most sagging in Coral Springs comes down to corroded hardware — the wire ties, tension bands, and tension bars that hold the fabric in place rust out faster here than in drier parts of the state. Once the hardware lets go, the fabric has nothing to hold it up.

Quick Answer

Chain link sags when the tension in the fabric lets go, usually because a tension bar or tie wire has failed. In Coral Springs, salt-laden air from the coast accelerates rust on the wire ties and fittings, and once a few of those fail the whole fabric droops. The fix involves tightening or replacing the tension bar and retying the fabric to the top rail. Call for an inspection if the sag is more than a few inches — a sagging fence is easy for a dog or intruder to push under.

Chain Link Fence Sagging in Coral Springs

Telltale Signs

Warning Signs to Watch For

  • The fabric dips down in a curve between two posts, especially in the middle of a long span
  • Wire ties holding the fabric to the top rail are broken, missing, or heavily rusted
  • The tension bar along the end post has slipped out of the tension bands
  • You can lift the bottom of the fabric several inches off the ground
  • The fabric has pulled away from the fence post entirely on one side
  • Rust streaks are visible running down from the wire ties onto the fabric

Root Causes

What Causes Chain Link Fence Sagging?

1

Corroded Wire Ties and Hardware

Wire ties are small aluminum or galvanized wire loops that hold the chain link fabric to the rail. In Coral Springs, the air carries enough salt and humidity that galvanized ties can rust through in as few as 5 to 7 years. Once several ties fail along a span, the fabric loses its attachment points and sags.

The Fix

Hardware Replacement with Aluminum Ties

We remove all the old wire ties and replace them with aluminum ties, which don't rust in coastal-influenced air. We also inspect and replace any tension bands or rail end caps that show heavy corrosion.

2

Undersized Post Spacing

Chain link fabric is meant to span no more than 10 feet between posts. In older Coral Springs neighborhoods built in the 1970s and 1980s, some fences were installed with posts 12 or even 15 feet apart to cut material costs. The extra span lets the fabric belly down under its own weight over time.

The Fix

Add Intermediate Line Posts

We dig and set additional line posts to bring the spacing down to the correct interval, then re-tension the fabric. Adding posts is a permanent fix because it removes the excess unsupported span.

3

Loose or Missing Tension Bar

A tension bar is a flat metal rod woven through the last row of the chain link at each end. It locks the fabric to the terminal post through tension bands. When that bar slips or corrodes through, the entire fabric panel loses its end anchor and the middle sags toward the loose end.

The Fix

Tension Bar Replacement and Fabric Re-tensioning

We install a new tension bar, thread it through the fabric end, and bolt it to fresh tension bands on the post. Then we pull the fabric tight from the opposite end before securing it.

Self-Diagnosis

Which Cause Applies to You?

Check the signs you're observing to narrow down the likely root cause before your inspection.

What You're Seeing Corroded Wire Ties and Hardware Undersized Post Spacing Loose or Missing Tension Bar
Wire ties are visibly broken or missing along the top rail
Sag is worst in the center of a very long span between posts
Fabric has pulled away from an end or corner post
Rust streaks run down the fabric from attachment points
Bottom of fabric can be lifted more than 6 inches off the ground